Prepare a Drill with square drill bit, blinds with brackets, and screws provided.

Roller blind

1. Nail both brackets at the same level on to each corner of the window frame. Male bracket goes to the control side, and vice versa.
2. Clip the control side of the blind with the chain on to the bracket and make sure the sticking metal parts are going into the side winder.
3. Clip in the other side of the bracket by putting the pin inside the female bracket.
4. Taking off your blinds from the brackets : As you wind the spiky part of the blind the metal pin will go inside the blind. Pull the blind down from the bracket and then the blinds will be off the brackets.

Vertical blind

< Roller Blinds - Inside mounting >

1. Screw the bracket on the top window frame (Left, Middle and Right).
2. Put the front side of vertical rail on the bracket by matching the end, and press up the rear part of the rail.
4. Put the top part of each slat onto each carrier on the rail. You will have to push until you hear two “clicking” sounds.

Measuring for curtain width

1.Measure Your Curtain Track or Pole

Curtain Track

Measure its full length, end to end.

Curtain Pole

Measure the pole length, not including the finials (the decorative pieces on the end).

Measuring for curtain length

1. Decide where your curtains will end

Sill Length

End 1.25cm above the windowsill.

Below sill

End 15cm below the windowsill.

Floor Length

End 1.25cm above the floor.

If you have a wall mounted heater below your window end your curtains 3cm above the heater to allow the heat to circulate into the room rather than rising up behind your curtains.

2. Measure the drop

Depending on your choice of fitting and curtain type, measure as follows:

Curtain track

Measure from the top of the track to your chosen end point. Our Pencil Pleat curtains have a header tape with 3 rows on which to attach your hooks. This allows you to adjust your curtains up or down by about 2cm by using the other rows.

Curtain Pole with Eyelet Curtains

If you're putting eyelet curtains on a pole you won't need to use curtain rings. The eyelets on the curtain slip directly onto the pole, so measure from the top of the pole to your chosen end point.

Curtain Pole with Pencil Pleat Curtains

If you're fitting pencil pleats on a pole, use the curtain rings that come in the pole pack. Measure from just below the pole, as this is where your curtains will hang after you've put the hooks into the loops on the curtain rings.

Measure at Multiple points

Windowsills and floors are not always level, so measure at 2 or 3 points and use the smallest measurement to ensure the best fit.